Rodgers Instruments W-5000 Guía de usuario Pagina 122

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 165
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 121
Chapter 10
122
GENERAL CONTROLS
[ROTARY] Parameters
These parameters affect the rotary simulator. Press the [ROTARY] button to access these parameters:
Rotary
Control: Intern, Extern, Both, None
This parameter allows you to select the type of rotary control. Use the [+] and [-] buttons. If set to 'Intern',
[ROTARY] and [FAST/SLOW] effects will only affect the internal rotary simulator.
Tw Level: 0-127
This parameter allows you to set the tweeter (high frequency driver) level. Press [NEXT] to select this
parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Wf Level: 0-127
This parameter sets the woofer (low frequency driver) level. Press [NEXT] to select this parameter. Use the
[+] and [-] (or [++]/[--]) buttons.
Separation: 0-127
This parameter sets the depth of tweeter modulation. Press [NEXT] to select this parameter. Use the [+] and
[-] (or [++]/[--]) buttons.
Wf ModDepth: 0-99
This parameter sets the woofer modulation depth. Press [NEXT] to select this parameter. Use the [+] and [-]
(or [++]/[--]) buttons.
DrySend Off: 0-99
This parameter sets the amount of Drawbar signal routed when the [ROTARY] button is off. Press [NEXT]
to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
DrySend On: 0-99
This parameter sets the amount of dry (straight) Drawbar signal routed when the [ROTARY] button is on.
Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
EfxSend On: 0-99
This parameter sets the amount of wet (processed) signal being mixed with the dry (straight) signal when the
[ROTARY] button is lit. Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Out Level: 0-127
This parameter sets the output level. Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--])
buttons.
Color: Mellow, Bright
This parameter sets the rotary simulator's tone color. Press [NEXT] to select this parameter. The 'Mellow'
setting simulates the installation of the tremolo rotor rear door, whereas 'Bright' simulates removal of the
door. Use the [+] and [-] buttons.
Vista de pagina 121
1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 164 165

Comentarios a estos manuales

Sin comentarios