Rodgers Instruments W-5000 Guía de usuario descargar pdf (Pagina 53)

Effects

Ê Select a Tone 1 and Tone 2 sound for the Upper manual. (Selecting Tones which have a very different

character will highlight the effect.)

Ë Press the [CROSSFADE] button (so the LED lights).

Ì Select 'Upper' as the keyboard. (Use the [+] button if it isn't already selected.)

Í Press [NEXT] until the word 'Mode' appears and press [+] to select 'Switch'.

Î Play the Upper manual softly and you should only hear Tone 1. Gradually play harder and harder. At

some point you'll only hear Tone 2.

The other Crossfade modes and related parameters are listed and explained on page 119.

[AFTERTOUCH] BUTTON

Aftertouch is modulation (or change) that occurs to a sound after the sound has been played. This

modulation is created by playing a note and then exerting further pressure on the key once it's down (at the

bottom of its travel). Only the W-5000's Lower manual is aftertouch sensitive.

The Aftertouch depth for Pitch, TVF Cutoff, Volume, LFO rate, LFO pitch depth, LFO TVF depth, LFO

TVA depth and expression can be set. All aftertouch parameters are set under the [CONTROLS] menu

(see page 69).

The [AFTERTOUCH] button is a general on/off switch for the aftertouch continuous controller.

Note: The aftertouch signal is also sent to the [CROSSFADE] button where it can be used in the '2nd Touch'

mode. In this case, aftertouch works regardless of the on/off setting of the [AFTERTOUCH] button.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 164 165

Sin comentarios

Rodgers Instruments W-5000 Guía de usuario Pagina 53