Rodgers Instruments W-5000 Guía de usuario Pagina 133

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 165
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 132
Appendix
133
Audio XRot
Main Sig: On, Off
This parameter allows you to turn the main external pre-rotary simulator Drawbar signal on and off. Press
[NEXT] to select this parameter. Use the [+] and [-] buttons. (This is the stationary (Ch. 2) channel of a
multi-channel external tone cabinet.)
Audio XRot
Aux Mix: Spkr, Line
This parameter allows you to determine what type of mix is sent to the stereo auxiliary channels of an
external tone cabinet. Press [NEXT] to select this parameter. Use the [+] and [-] buttons.
Audio XRot
Rev Send: 0-127
This parameter allows you to set the amount of pre-rotary simulator Drawbar signal being sent to the W-
5000's reverb unit. Press [NEXT] to select this parameter. Use the [+]/[-] (or [++]/[--]) buttons.
Audio Rev Return
Org Out: 0-127
This parameter allows you to set the amount of the W-5000's reverb signal being sent to the CLASSIC
OUTPUTs. Press [NEXT] to select this parameter. Use the [+]/[-] (or [++]/[--]) buttons.
Audio Rev Return
Dbar Out: 0-127
This parameter allows you to set the amount of the W-5000's reverb signal being sent to the post-rotary
simulator DRAWBAR OUTPUTs. Press [NEXT] to select this parameter. Use the [+]/[-] (or [++]/[--])
buttons.
Audio Rev Return
Spkr Mix: 0-127
This parameter allows you to set the amount of the W-5000's reverb signal being sent to the MIXED SPKR
OUTPUTs. Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Audio Rev Return
Line Mix: 0-127
This parameter allows you to set the amount of the W-5000's reverb signal being sent to the MIXED LINE
OUTPUTs. Press [NEXT] to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons.
Audio DB15
Mix LPF: On, Off
This parameter allows you to route the Mix signal (channels 7 and 8) through a low pass filter before going
to the 15-pin connector. Press [NEXT] to select this parameter. Use the [+] and [-] buttons.
Audio DB15
Mix Sel: Spkr, Line
This parameter allows you to select the Line or Speaker mix for output to channels 7 and 8 of the 15-pin
connector. Press [NEXT] to select this parameter. Use the [+] and [-] buttons.
[MIDI] Parameters
These parameters allow you to configure the instrument's MIDI Master System settings (a subset of the
standard Rodgers MIDI implementation). Press the [MIDI] button in the FUNCTIONS section to access
these parameters:
Vista de pagina 132
1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 164 165

Comentarios a estos manuales

Sin comentarios