
Chapter 10
130
[AUDIO] Parameters
These parameters allow you to configure the W-5000's audio system (refer to the Audio Block Diagram on
page 160 for additional information). Press the [AUDIO] button in the FUNCTIONS section to access these
parameters:
Audio Aux
Pad: L0-255 R0-255
The first parameter allows you to set the left AUX INPUT pad (attenuation) level. Press [NEXT] to select
this parameter. Use the [+] and [-] (or [++]/[--]) buttons. Press [NEXT] to select the 'R' parameter field. Set
the right attenuation pad with the [+] and [-] (or [++]/[--]) buttons. (A value of '0' completely mutes the input.
A value of '192' is 'Unity' gain. A value of '255' is +31.5dB.)
Audio Aux
Gain: +0db, +6db, +12db, +18db
This parameter allows you to set the AUX INPUT (L/R) gain level. Press [NEXT] to select this parameter.
Use the [+] and [-] buttons.
Audio Aux Left
Spkr: L0-127 R0-127
This parameter allows you to direct the left auxiliary input signal to either the left or right channels of the
Speaker mix. Press [NEXT] to select this parameter and to move to the next field. Use the [+] and [-] (or
[++]/[--]) buttons to set the relative levels.
Audio Aux Right
Spkr: L0-127 R0-127
This parameter allows you to direct the right auxiliary input signal to either the left or right channels of the
Speaker mix. Press [NEXT] to select this parameter and to move to the next field. Use the [+] and [-] (or
[++]/[--]) buttons to set the relative levels.
Audio Aux Left
Line: L0-127 R0-127
This parameter allows you to direct the left auxiliary input signal to either the left or right channels of the
Line mix. Press [NEXT] to select this parameter and to move to the next field. Use the [+] and [-] (or [++]/[--
]) buttons to set the relative levels.
Audio Aux Right
Line: L0-127 R0-127
This parameter allows you to direct the right auxiliary input signal to either the left or right channels of the
Line mix. Press [NEXT] to select this parameter and to move to the next field. Use the [+] and [-] (or [++]/[--
]) buttons to set the relative levels.
Audio Aux Left
DBar: L0-127 R0-127
This parameter allows you to direct the left auxiliary input signal to either the left or right DRAWBAR
OUTPUT jack. Press [NEXT] to select this parameter and to move to the next field. Use the [+] and [-] (or
[++]/[--]) buttons to set the relative levels.
Audio Aux Right
DBar: L0-127 R0-127
This parameter allows you to direct the right auxiliary input signal to either the left or right DRAWBAR
OUTPUT jack. Press [NEXT] to select this parameter and to move to the next field. Use the [+] and [-] (or
[++]/[--]) buttons to set the relative levels.
Comentarios a estos manuales