
Appendix
153
SOFTWARE UPDATES
The W-5000's operating (system) software can be updated from the disk drive. Software may be updated
from time to time to provide improvements or to add new features.
Your instrument was shipped with a 'System Disk' that contains the version of software installed in your unit.
Therefore, initially there is no need to update your system software. However, you should keep the latest
System Disk as a backup in the event that you encounter a problem. If your W-5000 ever requires servicing,
it's important that you have the latest System Disk available for the service technician.
To update your system software, please follow the simple procedure outlined below. Your W-5000 should
be up and running before you begin. If you have any questions, please contact your Rodgers dealer.
Ê Insert the System Disk into the disk drive.
Wait until the display no longer reads 'Loading Floppy (or Internal) Piston Memory...'
Ë Press the [UTILITY] button in the FUNCTIONS section (just under the LCD).
Ì Press the [NEXT] button until the words 'Utility Sys Protect' appear in the LCD.
Í Press the [+] or [-] button until the LCD reads 'Utility Sys Protect: Off'.
Î Press the [NEXT]/[PREVIOUS] buttons as necessary until the words 'Utility System Update (+)' appear.
Ï Press the [+] button to update the system software.
During the process, the LCD will display a percentage of completion (from 0% -- 100%) while the word
'Formatting...' is also displayed. Then the drive will access the disk and again a percentage of completion
(0% -- 100%) will be displayed. This time the word 'Reading...' will appear.
When the process is complete, the display will read 'System Updated, Rebooting...'. At this point, the
instrument will reset itself. Do not remove the disk until the reboot is complete. When you do remove the
floppy disk, the display will read 'Loading Internal Piston Memory...' for a few seconds. You can now play
your W-5000.
Comentarios a estos manuales